Search results

Jump to: navigation, search

Page title matches

  • #REDIRECT [[Sample Fn-F7 script]]
    33 B (4 words) - 16:55, 12 November 2007
  • The following script will suspend your notebook to ram, and output some statistics about the pow {{NOTE|This Script can be customized in numerous ways:
    8 KB (1,259 words) - 05:34, 15 January 2012
  • This is an example ACPI action script that makes Power Management adjustments according to if you are on battery After restarting your acpi daemon the script should be activated on switching the power supply on/off. You could check y
    3 KB (374 words) - 23:54, 8 January 2009
  • ==A comprehensive script== This Perl script periodically samples the tilt data reported by the accelerometer, computes
    11 KB (1,744 words) - 17:20, 5 August 2011
  • ...der]] under Linux is currently a fairly complicated process. The following script automates the installation of the fingerprint software, for some Linux dist ===Distributions supported by this script===
    3 KB (370 words) - 17:25, 5 August 2011
  • ...Tested on a ThinkPad {{600E}}). It is meant to be used as <tt>install</tt> script with <tt>modprobe</tt>. An example {{path|modprobe.conf}} snippet follows. Save this script as {{path|/usr/local/sbin/soundcard-on}}. Don't forget to make it executabl
    2 KB (334 words) - 23:50, 18 January 2009
  • This script helps in calibrating voltages when [[Pentium M undervolting and underclocki ...mailing list], perhaps even more can be done. Following such advice, this script not only runs MPrime, but also toggles on and off a lot of power-demanding
    20 KB (2,935 words) - 12:20, 12 September 2008
  • ...ify areas with higher-than-expected power draw. The ultimate goal of this script is to act as a tool that will ultimately allow you to maximize your battery The script is written in Python.
    1 KB (240 words) - 22:53, 19 August 2006
  • 633 B (86 words) - 13:26, 7 May 2007
  • This is a complete [[acpid]] and [[tpb]] script optimized for a Thinkpad [[Category:R51|R51]]. It is intended to be used by * ... See the beginning lines of the script for more detailled information.
    7 KB (987 words) - 23:51, 18 January 2009
  • 33 B (4 words) - 19:25, 8 September 2007
  • ...hen. When fglrx is used, aticonfig can be used for the switching in this [[Script for Dynamic Display Management with fglrx]]. # bash script
    31 KB (3,978 words) - 15:17, 21 May 2013
  • ...hinkpad [[:Category:T43|T43]]). When an external display is connected, the script switches from internal to both internal and extarnal, then to external only ==The Script==
    6 KB (823 words) - 23:49, 18 January 2009
  • ...program with similar functionality written in a different language on this script. {{NOTE|This script no longer works on '''Windows Vista'''.}}
    4 KB (601 words) - 14:52, 30 November 2008
  • #REDIRECT [[Python script for Windows to control ThinkPad features]]
    68 B (9 words) - 19:07, 15 March 2008
  • #REDIRECT [[Script for Undervolt Stress Testing]]
    49 B (6 words) - 12:20, 12 September 2008
  • Here is a very simple script that with switch your Thinkpad from the built-in display to an external dis This script relies on the program "disper", which provides a simple command to change b
    2 KB (296 words) - 17:20, 13 October 2009
  • #REDIRECT [[Script for enabling the fingerprint reader with BioAPI]]
    68 B (9 words) - 17:20, 5 August 2011
  • 1 KB (196 words) - 11:51, 10 December 2015

Page text matches

  • Using an [[Script for Dynamic Display Management with fglrx|ACPI script]], aticonfig can be used to switch displays on a key press.
    13 KB (1,798 words) - 02:17, 15 April 2013
  • ...add some udev.rules to allow user read/write access to nvram. Create a new script file called 10-local.rules in your udev rules definition directory on Gento * To automatically start xmodmap. Create an executable script file called xmodmap.sh
    4 KB (574 words) - 08:22, 15 January 2012
  • #REDIRECT [[Sample Fn-F7 script]]
    33 B (4 words) - 16:55, 12 November 2007
  • ...[[ACPI fan control script#Variable speed control scripts|ACPI fan control script]].
    14 KB (2,274 words) - 20:34, 10 December 2011
  • === ACPI sleep drain test script === ...n test if your laptop suffers from the Radeon ACPI problems by running the script available at [http://www.thinkwiki.org/wiki/ACPI_sleep_power_drain_test_scr
    11 KB (1,570 words) - 11:06, 18 June 2015
  • In this example, I tell it to invoke the script <tt>~/toggle-touchpad.sh</tt>, which you can create like this: Second, create the referenced action script (<tt>/etc/acpi/twist-tabletmode.sh</tt>):
    13 KB (1,880 words) - 03:30, 29 January 2013
  • ...g in laptop-mode when resuming from suspend, so you have to write a simple script in {{path|/etc/apm/resume.d}} that restarts it. It gets automatically execu
    4 KB (617 words) - 17:40, 18 October 2006
  • *[[HDAPS]] with [[Script for theft alarm using HDAPS]]
    6 KB (872 words) - 16:08, 16 February 2010
  • ...2.6.10] [http://www.viehland.net/jeremy/other/ultracam-2.6.10.html Install script for the IBM Ultraport Camera (Ultracam) driver for the 2.6.10 Linux Kernel]
    2 KB (243 words) - 02:04, 25 February 2008
  • *[[Script for configuring the CS4239 sound chip in PnP mode|CS4239 sound chip in PNP
    4 KB (612 words) - 16:54, 5 August 2011
  • acpid script for suspending (to ram) when the lid is closed<br /> ...NUALY /var/cache/acpi OR THE SCRIPT WON'T WORK, YOU *NEED* IBM ACPI OR THE SCRIPT WON'T DO ANYTHING /!\
    7 KB (991 words) - 15:40, 16 March 2017
  • drive is inserted into the Ultrabay. So you can make a script realise that the human readable
    1 KB (220 words) - 22:43, 24 September 2004
  • ...gement). You may want to turn power management on/off on demand in an ACPI script that catches battery/AC events, so that this happens automatically.
    12 KB (1,866 words) - 11:29, 18 November 2010
  • ...acpi]], [[#tpb configuration|tpb]] || additional actions || [[Sample Fn-F7 script]] ...nts detected by HAL such a special key press. For example, to run a custom script when Fn-F5 (Radio toggle) is pressed, you could put a stanza in halevt's co
    44 KB (6,541 words) - 02:13, 15 February 2016
  • There's also a script called [http://fdd.com/software/radeon/lightwatch.pl lightwatch.pl] availab
    1 KB (211 words) - 13:34, 20 April 2009
  • ...logs/page/johnston?entry=python_and_thinkpad Python and ThinkPad, a Python script for Windows to access the sensor data] (comments are spam fooded)
    8 KB (1,261 words) - 17:30, 29 November 2010
  • * script to run when in X:
    4 KB (636 words) - 14:30, 2 March 2010
  • ...ibly other lights on your Thinkpad) it comes with the daemon and a control script. *The [[script for theft alarm using HDAPS]] optionally flashes the ThinkLight when the al
    6 KB (921 words) - 10:44, 12 November 2018
  • # -*- Mode: shell-script -*-
    12 KB (2,003 words) - 02:46, 27 November 2007
  • Get ubuntulinux, radeontool and this script (which goes in /etc/acpi), nothing more!
    5 KB (814 words) - 21:36, 6 January 2017

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)