Search results
Create the page "Latch" on this wiki! See also the search results found.
- [ 729.462894] hdaps: initial mode latch is 0x0523 KB (3,256 words) - 01:42, 26 March 2020
- == Table of latch data from the (experimental) hdaps driver == !ThinkPad!!bios firmware!!latch!!flip!!Value at 1.75 radians (see below)!!Value at 0.75 radians !! Value at5 KB (822 words) - 18:16, 29 November 2010
- ...h a gap of approximately 3/16 of an inch gap in the front, and no positive latch on the front, only in the back, but the two 'lock-up. I am currently using2 KB (405 words) - 05:40, 15 April 2012
- ...voltage between pin 11 and ground (can be found for example on the MiniPCI latch arms) - it should give you about 3.3V while the WiFi is active and 0V other ...to connect the other end to the ground. The best place is the left MiniPCI latch arm. Bend it outside and insert the wire into the small gap between the two38 KB (5,583 words) - 19:48, 6 May 2018
- ...laptop, I'd say the hottest part of that area is between the grill and the latch for the DRAM expansion (probably below the thing in the center of your phot31 KB (5,305 words) - 09:24, 8 November 2009
- {{cmdresult|hdaps: initial latch check good (0x01).}}19 KB (3,033 words) - 17:32, 5 August 2011
- [ 893.752000] hdaps: initial mode latch is 0x0523 KB (3,641 words) - 01:45, 24 August 2008
- [[User:Latch|Latch]] 01:22, 14 June 2007 (UTC)45 KB (7,622 words) - 19:32, 4 May 2017
- hdaps: initial mode latch is 0x058 KB (1,056 words) - 00:02, 17 January 2011