Difference between revisions of "Installing Slackware on a Thinkpad W520"
(â†Created page with '== Installation == Slackware 13.37 64-bit installed like a breeze on a hot, humid day! For the most part all of the essentials to get the system up and running on the W5...')
Revision as of 02:41, 3 July 2011
Slackware 13.37 64-bit installed like a breeze on a hot, humid day! For the most part all of the essentials to get the system up and running on the W520 was detected and put into play with little or no intervention or editing of files on my end.
Coming from a W510, the W520 introduced me to the concepts of discrete and integrated graphics, as well as NVIDIA's Optimus technology.
The first decision is whether you want to use the NVidia discrete graphics (faster) or the Intel HD integrated graphics (more power-efficient). Both are more than fast enough for office graphics, the only noticeable speed difference is in 3D acceleration. You must set the graphics mode in the BIOS accordingly to discrete or integrated only. Do not leave it at the default "Optimus" as it is undocumented and unsupported.
The following notes refer to the NVidia discrete graphics only. Fedora uses the reverse-engineered Nouveau driver in this case, which currently is restricted to 2D graphics. If you need 3D acceleration, you have to install the binary-only NVidia drivers. The easiest way is to configure teh RPM fusion repository and follow their NVidia HowTo. This amounts to running
# yum localinstall --nogpgcheck http://download1.rpmfusion.org/free/fedora/rpmfusion-free-release-stable.noarch.rpm
# yum localinstall --nogpgcheck http://download1.rpmfusion.org/nonfree/fedora/rpmfusion-nonfree-release-stable.noarch.rpm
# yum install kmod-nvidia
The backlight control does not work by default with the NVidia driver, to get it to work you have to add Option "RegistryDwords" "EnableBrightnessControl=1" to the Device section of your /etc/X11/xorg.conf.
I have the Intel Centrino Ultimate-N 6300 card and it works out of the box.
The e1000e driver in Fedora 14 is too old for the ethernet chip. To get it to work you have to download and compile the updated driver from Intel's web page. You don't have to recompile the whole kernel; Just unpack, make, and
# insmod ./e1000e.ko