Extending battery life on X200

From ThinkWiki
Revision as of 00:56, 4 March 2009 by Alain (Talk | contribs) (Turning off Gnome Power Manager)

Jump to: navigation, search

Overview

I own the beautiful Lenovo X200 and run Ubuntu Intrepid on the machine. Its battery life is significantly lower than that under Windows and many users have reported that it runs hotter than under Windows.

With the changes below and a 9 cell battery I get over 9 hours on an idle system with backlight at the lowest level and wireless radios off. Before the changes I was only getting 5 hours.

The system also runs a lot cooler and I do not need tpfan (sw fan control for the ThinkPad available here), the built-in hw controller falls back to the lower speeds shortly after a CPU load subsides.

Details

The changes fall into 3 categories:

  • Removing packages that create unnecessarily frequent wake up interrupts.
    • These interrupts wake up the CPU, preventing it from staying in its most energy efficient state.
    • I used Powertop from www.lesswatts.org for this task.
  • Lowering the voltage supplied to the CPU.
    • Lowering CPU voltage does not impact performance since the clock frequency is unaffected
    • I used phc patches and phctools available at www.linux-phc.org for this task.
  • Turning off radios you do not need
    • My X200 has 3 wireless radios: Wifi, Blutooth, Broadband wireless

Finding and removing high interrupt packages

Install PowerTOP from here.

Run PowerTOP as root (sudo powertop) and look for the packages that come up on top of the interrupt frequency list. These are the packages that wake up the CPU most frequently.

In my case the majority of the easily preventable interrupts were from 3 packages:

  • i915, the intel graphics driver
  • SCIM
  • Gnome Power Manager

With the first one accounting for the bulk of the battery life improvement.

The %'s in PowerTOP give you an indication of what to focus on, no need to worry about a 1% problem (unless it is easy to prevent that it), it will not have much impact on your battery life.

Remember that over time these packages will improve and will not need to be removed.

Turning off DRI

Just insert: Option "NoDRI" to the "Device" section in /etc/X11/xorg.conf. This turns off all 3D, so no compiz or other fancy effect. Worth it for me because the impact on battery life is substantial.

Turning off SCIM

I had my system set to accept foreign characters. Going to System > Language Support > Disable support to enter complex characters does the trick.

Turning off Gnome Power Manager

You may decide you cannot live without it, but on my system I disabled Gnome Power Manager from the startup list: System > Sessions > Power Management daemon.

I replaced it with the Gnome Panel Battery Charge Monitor (Add to Panel...) which works well enough for me.

Reducing CPU voltage

Installing phc module patches

The phc module patches are available here, make sure you get the version that matches you kernel version. You can easily check by typing uname -r in a console.

You need not compile your own module, check the thread, users have posted already compiled versions of the acpi-cpufreg.ko module for most kernel versions.

Once you have the apci-cpufreq.ko module, back up the old module:

sudo cp /lib/modules/$(uname -r)/kernel/arch/x86/kernel/cpu/cpufreq/acpi-cpufreq.ko  /lib/modules/$(uname -r)/kernel/arch/x86/kernel/cpu/cpufreq/acpi-cpufreq.ko.bak

Then copy the new module to the right place:

sudo cp acpi-cpufreq.ko    /lib/modules/$(uname -r)/kernel/arch/x86/kernel/cpu/cpufreq

Restart your system and check that you now have voltage controls by typing: more /sys/devices/system/cpu/cpu0/cpufreq/phc_vids

You should see something like: 39 25 17 13 (your values may be different). These are the voltage values for the 4 frequencies available on your CPU

Intalling phctools

Experimenting with lower voltages

Making the voltages stick

Turning off the wireless radios