Search results
Create the page "Force" on this wiki! See also the search results found.
- ...om 1400x1050 to 1024x768) or by switching off the graphics with "xset dpms force off". The bottom line is that the below "partial fix" won't work because t ...on, you are more than qualified to do the procedure. Just remember do NOT force anything, at several steps there are tiny plastic "tabs" that can break off14 KB (2,274 words) - 21:34, 10 December 2011
- | 2.6.15.4 || Force || [http://hanselan.de/ibm/config-2.6.15.4 For an X21 with ACPI and Suspend7 KB (996 words) - 22:37, 31 December 2020
- ...07.ibm.com/pc/support/site.wss/ check online] if your warranty is still in force.13 KB (2,122 words) - 13:31, 26 January 2011
- ...previous TrackPoint as it was occasionally over-exaggerating the amount of force applied to it, making it inaccurate/too fast or difficult to use. ...lmaden.ibm.com/cs/new_paradigms/tpscienc.html TrackPoint Science] Gets raw force data from the TrackPoint.5 KB (735 words) - 17:01, 22 January 2021
- # Use SWSUSP_FORCE_SUSPEND_MODE to force use the SWSUSP feature # behaviour unchanged. "0" will force shut off after12 KB (2,003 words) - 03:46, 27 November 2007
- ...arly, if the patch is not automatically activated on your notebook you can force it by {{bootparm|video|radeonfb:force_sleep|1}}. In case that improves your ...you think that your computer would profit from the patch as well, you can force it by including the module parameter {{bootparm|video|radeonfb:force_sleep|12 KB (1,861 words) - 23:40, 28 October 2009
- Running {{cmduser|xset +dpms}} and then {{cmduser|xset dpms force off}} will turn off the backlight on a laptop screen.<br />8 KB (1,261 words) - 03:24, 28 October 2015
- ...-- using the RMClock utility you can disable C4 to C1/C2/C3 transition and force the CPU to go straight to C0. To do this, in RMClock settings go to: "Enabl22 KB (3,464 words) - 04:09, 22 January 2014
- *ThinkPad {{390X}} with kernel boot option ACPI=force4 KB (581 words) - 19:47, 14 January 2011
- ...of type (LCD, CRT...). The option '''MergedNonRectangular''' is needed to force the screens into two different sizes.9 KB (1,249 words) - 01:57, 27 June 2009
- ...cards will work. 32-bit or CardBus cards will not fit in the slots without force and will not work if forced.7 KB (1,176 words) - 18:21, 8 April 2009
- stop|reload|restart|force-reload) echo "Usage: $N {start|stop|restart|force-reload}" >&2513 bytes (65 words) - 19:11, 18 December 2006
- xset -display $DISPLAY dpms force off xset -display $DISPLAY dpms force on # turn monitor on10 KB (1,527 words) - 16:49, 19 September 2010
- ...v5.39). You need to delete the .inf supplied by Microsoft (neo20xx.inf) to force an install of the IBM driver as Win2k will otherwise prefer the Microsoft o3 KB (404 words) - 14:57, 22 January 2021
- ...upported. But note that for working suspend/resume support it is needed to force AGP 1X mode by passing {{bootparm|radeon.agpmode|1}} at boot time. This can3 KB (401 words) - 14:50, 22 January 2021
- ...the possibility to either have the monitor connected during X startup, or force activation of both ports by adding6 KB (901 words) - 14:52, 22 January 2021
- * Corsair Force F115 * Corsair Force F120543 bytes (86 words) - 18:53, 17 May 2011
- ...recommended to edit {{path|/boot/grub/grub.conf}} and add {{bootparm|hpet|force}} to the kernel line. This will activate HPET (High Precision Event Timer),8 KB (1,198 words) - 12:30, 7 December 2011
- # -acpi disables cpufreq and force the use of acpi2 KB (328 words) - 17:30, 10 December 2008
- You can automatically force the pm-utils to reload this module. | Minimum amount of force needed to trigger dragging26 KB (3,831 words) - 03:59, 11 May 2017
- ...es together, so be gentle with it as it could break or snap with excessive force.14 KB (2,255 words) - 19:03, 11 November 2020
- ...y drivers' hardware auto-detection cannot be relied upon. However, you can force the floppy driver to use both of them by adding the following line to {{pat2 KB (287 words) - 17:34, 12 October 2020
- # Setup and force TRIM in fstab with the following options in your /etc/fstab '''discard, noa5 KB (691 words) - 20:22, 17 January 2015
- ...y drivers' hardware auto-detection cannot be relied upon. However, you can force the floppy driver to use both of them by adding the following line to {{pat2 KB (284 words) - 19:24, 12 October 2020
- The simplest way to enable DMA is to force the IDE driver to ignore the system hard disk by passing the {{bootparm|hda14 KB (2,255 words) - 21:16, 14 June 2009
- ...sion (8.20.8) under Debian sid and you upgrade your xserver-xorg, apt will force you to remove any debian-packaged fglrx drivers (package fglrx-driver depen 1/ Open the Catalyst Control Center and force the anti-aliasing to at least 2x for all applications. This surprisingly fi30 KB (4,482 words) - 03:47, 17 November 2009
- return "force"; } elsif ($kls eq 'force') { # screen saver with forced lock23 KB (3,067 words) - 06:15, 22 January 2014
- To force battery discharging (even if connected to AC):30 KB (4,046 words) - 10:29, 1 May 2016
- ...th the boot option no_suspend_console, you my try to enable hpet with hpet=force10 KB (1,349 words) - 01:37, 22 May 2009
- hpet=force Note that "hpet=force" is only available by default in 2.6.24-rc2 and above27 KB (4,366 words) - 03:23, 28 October 2015
- You can force the <tt>radeon</tt> driver to enable both CRT and LCD using <tt>Option "Mon9 KB (1,494 words) - 05:05, 31 October 2009
- ...d, so "Disable" is the best setting (in some cases, the BIOS will actually force you to set "Disable" if it detects that the HPA has been deleted).12 KB (2,012 words) - 23:37, 27 January 2014
- {{HINT|To force engaged mode using [http://www.staff.uni-marburg.de/~schmitzr/donate.html T15 KB (2,183 words) - 15:17, 4 November 2020
- Force the use of <tt>suspend2</tt> by editing the appropriate lines in {{path|/et13 KB (1,813 words) - 03:46, 26 October 2008
- Udisks reads device properties from udev. In order to force a device to be considered "removeable" we have to set the udev property "UD31 KB (4,750 words) - 02:58, 11 January 2024
- git status > /dev/null # Force check of files for which only the timestamp changed.13 KB (1,851 words) - 11:17, 7 November 2007
- ...OSes, and will malfunction if you pick the wrong one and somehow manage to force it to install.}}17 KB (1,774 words) - 19:38, 1 November 2017
- reload|force-reload|restart) echo "Usage: /etc/init.d/$NAME {start|stop|reload|restart|force-reload}" >&22 KB (203 words) - 06:53, 12 April 2007
- # To move windows across screen we need Xinerama and will have to force25 KB (3,612 words) - 08:00, 2 March 2008
- * Probe for usable interrupts using the force7 KB (1,064 words) - 13:55, 19 March 2010
- acpi=force pci=noacpi7 KB (1,202 words) - 17:13, 14 February 2008
- ...ed by default. You will most likely want to enable it. To do so, add 'acpi=force' to the line in /boot/grub/menu.lst beginning '# defoptions='. Then (as roo to update the acpi=force setting (see below).13 KB (2,132 words) - 04:57, 2 July 2008
- fprintf (stderr, "brute force GNOME_SUDO_PASS ended...\n");20 KB (2,895 words) - 16:08, 2 December 2015
- Force battery discharge: $BATT_FORCE_DISCHARGE7 KB (938 words) - 14:57, 1 June 2007
- restart|force-reload) echo "Usage: $SCRIPTNAME {start|stop|restart|force-reload}" >&24 KB (506 words) - 21:27, 2 June 2007
- Force the use of <tt>suspend2</tt> by editing the appropriate lines in {{path|/et12 KB (1,663 words) - 19:44, 21 October 2007
- # * F2: dpms force off (Blank screen) xset dpms force on7 KB (987 words) - 00:51, 19 January 2009
- ...Yet, thanks to the Udo A. Steinberg and Venki Pallipadi, we have a way to force enable HPET on chipsets known to support it (this include ICH3-M, ICH4-M, I 3) hpet is now in the ubuntu sources. However, you have to boot with hpet=force to get it work.18 KB (2,821 words) - 16:46, 5 August 2011
- action=/etc/acpi/sleep.sh force The '''force''' option in {{path|ibm-sleepbtn}} is necessary on my distribution because6 KB (977 words) - 16:54, 16 February 2009
- su $user -c "xset dpms force on" #su $user -c "xset dpms force off"31 KB (3,978 words) - 16:17, 21 May 2013