Search results

Create the page "Force" on this wiki! See also the search results found.

• ThinkWiki:Sandbox
  || <pre> </pre> <!--Hack to force column wider-->
  4 KB (619 words) - 22:21, 19 September 2014
• Problem with fan noise
  ...om 1400x1050 to 1024x768) or by switching off the graphics with "xset dpms force off". The bottom line is that the below "partial fix" won't work because t ...on, you are more than qualified to do the procedure. Just remember do NOT force anything, at several steps there are tiny plastic "tabs" that can break off
  14 KB (2,274 words) - 21:34, 10 December 2011
• Configs
  | 2.6.15.4 || Force || [http://hanselan.de/ibm/config-2.6.15.4 For an X21 with ACPI and Suspend
  7 KB (996 words) - 22:37, 31 December 2020
• Ordering Recovery CDs
  ...07.ibm.com/pc/support/site.wss/ check online] if your warranty is still in force.
  13 KB (2,122 words) - 13:31, 26 January 2011
• TrackPoint
  ...previous TrackPoint as it was occasionally over-exaggerating the amount of force applied to it, making it inaccurate/too fast or difficult to use. ...lmaden.ibm.com/cs/new_paradigms/tpscienc.html TrackPoint Science] Gets raw force data from the TrackPoint.
  5 KB (735 words) - 17:01, 22 January 2021
• Talk:Ultrabay
  On my 770x under ACPI, if you force the floppy driver to use 2 3.5" drives (in modprobe.conf options floppy flo
  10 KB (1,523 words) - 19:32, 14 March 2020
• Installing Mandriva Linux on a ThinkPad T20
  # Use SWSUSP_FORCE_SUSPEND_MODE to force use the SWSUSP feature # behaviour unchanged. "0" will force shut off after
  12 KB (2,003 words) - 03:46, 27 November 2007
• Problem with high power drain in ACPI sleep
  ...arly, if the patch is not automatically activated on your notebook you can force it by {{bootparm|video|radeonfb:force_sleep|1}}. In case that improves your ...you think that your computer would profit from the patch as well, you can force it by including the module parameter {{bootparm|video|radeonfb:force_sleep|
  12 KB (1,861 words) - 23:40, 28 October 2009
• How to make ACPI work
  Running {{cmduser|xset +dpms}} and then {{cmduser|xset dpms force off}} will turn off the backlight on a laptop screen.<br />
  8 KB (1,261 words) - 03:24, 28 October 2015
• Problem with high pitch noises
  ...-- using the RMClock utility you can disable C4 to C1/C2/C3 transition and force the CPU to go straight to C0. To do this, in RMClock settings go to: "Enabl
  22 KB (3,464 words) - 04:09, 22 January 2014
• Problem with LCD backlight remaining on during ACPI sleep
  *ThinkPad {{390X}} with kernel boot option ACPI=force
  4 KB (581 words) - 19:47, 14 January 2011
• Additional options for the radeon driver
  ...of type (LCD, CRT...). The option '''MergedNonRectangular''' is needed to force the screens into two different sizes.
  9 KB (1,249 words) - 01:57, 27 June 2009
• Talk:BIOS Upgrade
  == Force Upgrade a Thinkpad T20 to latest Thinkpad T22 BIOS == i managed to force upgrade my t20 to a t22 bios using a strange method.
  25 KB (4,164 words) - 23:27, 17 August 2013
• 750 Family Device Support in Linux
  ...cards will work. 32-bit or CardBus cards will not fit in the slots without force and will not work if forced.
  7 KB (1,176 words) - 18:21, 8 April 2009
• Code/fan-enable.init
  stop|reload|restart|force-reload) echo "Usage: $N {start|stop|restart|force-reload}" >&2
  513 bytes (65 words) - 19:11, 18 December 2006
• Talk:Problem with fan noise
  ...l, things should be pretty safe temperature-wise. For extra safety you can force the CPU to its lowest speed via {{path|/sys/devices/system/cpu/cpu0/cpufreq I even tried to force the fan to different speeds (with ''# echo 0x2F 0x07 > /proc/acpi/ibm/ecdum
  27 KB (4,663 words) - 01:46, 3 March 2009
• How to configure acpid
  xset -display $DISPLAY dpms force off xset -display $DISPLAY dpms force on # turn monitor on
  10 KB (1,527 words) - 16:49, 19 September 2010
• Neomagic MagicGraph256ZX
  ...v5.39). You need to delete the .inf supplied by Microsoft (neo20xx.inf) to force an install of the IBM driver as Win2k will otherwise prefer the Microsoft o
  3 KB (404 words) - 14:57, 22 January 2021
• ATI Mobility Radeon 9000
  ...upported. But note that for working suspend/resume support it is needed to force AGP 1X mode by passing {{bootparm|radeon.agpmode|1}} at boot time. This can
  3 KB (401 words) - 14:50, 22 January 2021
• ATI Mobility Radeon X300
  ...the possibility to either have the monitor connected during X startup, or force activation of both ports by adding
  6 KB (901 words) - 14:52, 22 January 2021
• SSD in T520
  * Corsair Force F115 * Corsair Force F120
  543 bytes (86 words) - 18:53, 17 May 2011
• Installing Fedora 15 on a ThinkPad X40
  ...recommended to edit {{path|/boot/grub/grub.conf}} and add {{bootparm|hpet|force}} to the kernel line. This will activate HPET (High Precision Event Timer),
  8 KB (1,198 words) - 12:30, 7 December 2011
• How to configure cpudynd
  # -acpi disables cpufreq and force the use of acpi
  2 KB (328 words) - 17:30, 10 December 2008
• Talk:TCPA/TCG - Trusted or Treacherous
  ...m different sides... the software and the law. These both could eventually force you using it. However, i think there's no need to by a A30 or whatever, jus
  17 KB (3,063 words) - 17:28, 26 January 2006
• How to configure the TrackPoint
  You can automatically force the pm-utils to reload this module. | Minimum amount of force needed to trigger dragging
  26 KB (3,831 words) - 03:59, 11 May 2017
• How to build your own Ultrabay drive
  ...es together, so be gentle with it as it could break or snap with excessive force.
  14 KB (2,255 words) - 19:03, 11 November 2020
• UltraBay II Floppy Drive
  ...y drivers' hardware auto-detection cannot be relied upon. However, you can force the floppy driver to use both of them by adding the following line to {{pat
  2 KB (287 words) - 17:34, 12 October 2020
• X1 Linux Tweaks
  # Setup and force TRIM in fstab with the following options in your /etc/fstab '''discard, noa
  5 KB (691 words) - 20:22, 17 January 2015
• UltraslimBay Floppy Drive
  ...y drivers' hardware auto-detection cannot be relied upon. However, you can force the floppy driver to use both of them by adding the following line to {{pat
  2 KB (284 words) - 19:24, 12 October 2020
• Problems with SATA and Linux
  The simplest way to enable DMA is to force the IDE driver to ignore the system hard disk by passing the {{bootparm|hda
  14 KB (2,255 words) - 21:16, 14 June 2009
• Talk:How to setup boot loaders
  Using the force-lba option in GRUB made the stage 1 loadable but not stage 2. And asking fo (If you really want this, use the --force option.)
  4 KB (600 words) - 07:18, 12 April 2007
• Problems with fglrx
  ...sion (8.20.8) under Debian sid and you upgrade your xserver-xorg, apt will force you to remove any debian-packaged fglrx drivers (package fglrx-driver depen 1/ Open the Catalyst Control Center and force the anti-aliasing to at least 2x for all applications. This surprisingly fi
  30 KB (4,482 words) - 03:47, 17 November 2009
• Talk:Problem with non-ThinkPad hard disks
  Did anyone try to use the flasher (HFUT10.EXE) to force flash with AB223E.CD2?
  13 KB (2,217 words) - 18:48, 1 April 2010
• Code/tp-theft
  return "force"; } elsif ($kls eq 'force') { # screen saver with forced lock
  23 KB (3,067 words) - 06:15, 22 January 2014
• Talk:HDAPS
  ...using the (older) sysfs interface. It also consumes enough CPU cycles to force my CPU back on periodically, consuming more power. Has anybody else had th
  11 KB (1,889 words) - 01:33, 28 June 2011
• Talk:Hard disk drives
  ...by Hitachi and they only sell the same disk but with a ZIF (Zero Insertion Force) connector.
  6 KB (1,018 words) - 16:44, 5 August 2011
• Talk:Predesktop Area
  ...: do not write in or otherwise use the HPA area; unless the user gives a --force option or something similar).
  21 KB (3,356 words) - 21:05, 20 December 2019
• Tp smapi
  To force battery discharging (even if connected to AC):
  30 KB (4,046 words) - 10:29, 1 May 2016
• TuxOnIce
  ...th the boot option no_suspend_console, you my try to enable hpet with hpet=force
  10 KB (1,349 words) - 01:37, 22 May 2009
• Talk:Problems with fglrx
  ...rst limitation (<<6.8.99) is what prevents installation. I'm sure I could force apt to install it, but I may go back to compiling the modules myself, as us
  16 KB (2,581 words) - 10:53, 21 June 2007
• How to reduce power consumption
  hpet=force Note that "hpet=force" is only available by default in 2.6.24-rc2 and above
  27 KB (4,366 words) - 03:23, 28 October 2015
• Problem with video output switching
  You can force the <tt>radeon</tt> driver to enable both CRT and LCD using <tt>Option "Mon
  9 KB (1,494 words) - 05:05, 31 October 2009
• Hidden Protected Area
  ...d, so "Disable" is the best setting (in some cases, the BIOS will actually force you to set "Disable" if it detects that the HPA has been deleted).
  12 KB (2,012 words) - 23:37, 27 January 2014
• Talk:Tp smapi
  force discharge from the battery with more capacity left force charging to the battery with less capacity left
  57 KB (9,382 words) - 16:48, 29 March 2013
• How to control fan speed
  {{HINT|To force engaged mode using [http://www.staff.uni-marburg.de/~schmitzr/donate.html T
  15 KB (2,183 words) - 15:17, 4 November 2020
• Installing Fedora Core 5 on a ThinkPad X41 Tablet
  Force the use of <tt>suspend2</tt> by editing the appropriate lines in {{path|/et
  13 KB (1,813 words) - 03:46, 26 October 2008
• How to hotswap Ultrabay devices
  Udisks reads device properties from udev. In order to force a device to be considered "removeable" we have to set the udev property "UD
  31 KB (4,750 words) - 02:58, 11 January 2024
• Code/build-experimental-X
  git status > /dev/null # Force check of files for which only the timestamp changed.
  13 KB (1,851 words) - 11:17, 7 November 2007
• BIOS Upgrade Downloads
  ...OSes, and will malfunction if you pick the wrong one and somehow manage to force it to install.}}
  17 KB (1,774 words) - 19:38, 1 November 2017
• Code/tp-fancontrol.init
  reload|force-reload|restart) echo "Usage: /etc/init.d/$NAME {start|stop|reload|restart|force-reload}" >&2
  2 KB (203 words) - 06:53, 12 April 2007

View (previous 50 | next 50) (20 | 50 | 100 | 250 | 500)