Problem with e1000: EEPROM Checksum Is Not Valid

From ThinkWiki
Revision as of 00:55, 10 December 2006 by Swente (Talk | contribs) (Circumvention)
Jump to: navigation, search

Problem Description

On certain ThinkPads, e1000 driver for Intel Gigabit controller fails to load with the following error message in /var/log/messages:

e1000: 0000:02:00.0: e1000_probe: The EEPROM Checksum Is Not Valid
e1000: probe of 0000:02:00.0 failed with error -5 

Circumvention

  • Upgrade your BIOS

Lenovo has published newer BIOS revisions that appear to fix the issue for some users. The BIOS upgrade turns off "Deep smart power down" which has been known to cause issues at initialization time (the driver can re-enable the issue later if you desire, the feature works correctly then).

  • Insert a cable

Inserting a linked network cable bypasses the problem.

  • Take the checksum twice

This bug report describes a fix -- take the checksum twice. First time will report a bad checksum, second will work (the problem seems to be triggered by some power-saving technology). This requires a tweak to the driver source and a rebuild of your kernel. This is much better than a previous "fix" published here that disabled checksum checking entirely.

  • Remove/add kernel module

Removing and adding the kernel module is a possible work-around. As root, run

# modprobe -r e1000
# modprobe e1000

On some occasions, the commands have to be run twice before eth0 becomes useable. On some X60s this will not work at all.

  • Disabling and re-enabling the NIC in the BIOS

For some it fixed the issue finally, for some it helped just temporarily.

See also