Opening port replicator II

From ThinkWiki
Revision as of 01:40, 17 September 2013 by Ilakast (Talk | contribs) (Problem: Thinkpad won't detach from Port Replicator)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Problem: Thinkpad won't detach from ThinkPad Port Replicator II

Cause: Link from button to release lever has come loose

Port Replicator II Lock.jpg

Solution 1: Add an emergency release hole

 * Drill a small hole as shown appr. 94mm from the front:

Port Replicator II Side.jpg

 * Seen from the inside, it should look like this:

Port Replicator II Detail.jpg

 * Now push carefully with a nail, your drill, or another sturdy pin to release the Thinkpad

Solution 2: Open Port Replicator

 * If no Thinkpad is attached, you can open the Port Replicator like this:
 * Remove 5 screws from button, pry with flat-bladed screwdriver at the marked points no the back:

Port Replicator II Backside.jpg