Difference between revisions of "Installing Ubuntu 6.10 on a ThinkPad X40"
(→Success Chart) |
|||
| Line 30: | Line 30: | ||
|colspan=2| Harddisk Active Protection ||class="diff-context"| Unknown | |colspan=2| Harddisk Active Protection ||class="diff-context"| Unknown | ||
|- | |- | ||
| − | |rowspan= | + | |rowspan=3|Extra Buttons |
| {{key|Fn}}{{key|F4}}||class="diff-addedline"| Yes | | {{key|Fn}}{{key|F4}}||class="diff-addedline"| Yes | ||
|- | |- | ||
Revision as of 14:07, 11 November 2006
This document describes the process of installing and configuring the release version of Ubuntu Edgy Eft on a Lenovo ThinkPad X40.
Contents
Success Chart
| Item | Working | |
| Installation | Network Installation | Unknown |
| USB Installation | Yes (CD) | |
| Display | Laptop Screen | Yes |
| CRT / Projector | Yes | |
| Power Management | Software Suspend (hibernate) | Yes |
| Suspend to Memory (ACPI sleep) | Yes | |
| Audio | Yes | |
| Wireless | 802.11b/g | Yes |
| Bluetooth | Unknown | |
| Harddisk Active Protection | Unknown | |
| Extra Buttons | FnF4 | Yes |
| FnF5 | Only toggles Bluetooth Power | |
| FnF12 | Yes | |
| Suspend to Memory (ACPI sleep) | Yes | |
Pre-Installation Notes
Wireless Support
Wireless seems to be supported flawlessly in terms of drivers, though I'm not sure how well the built-in Network Manager works. I use the iwconfig command to manage my wireless, as I have a need to create pseudo-"profiles", and in this document I will describe this alternative process.
Terminology Used
For those of you new to Linux, I'll try to detail a few terms I use with little explanation:
- Xorg configuration -- the display configuration file, residing in /etc/X11/xorg.conf
- Execute a command -- press Alt-F2, then type gnome-terminal into the prompt and press enter -- this is a terminal into which you input said commands
Installation Notes
Post-Installation Notes
Configuring Wireless
Renaming Wireless Interface
By default, the internal Intel 2200BG wireless card was named eth0. Aside from being annoying it also causes the Network Monitor to mistake the wireless card for a standard ethernet card. To rename it to wlan0 edit the file /etc/iftab: Change
eth0 mac <mac address> arp 1 eth1 mac <mac address> arp 1
to
eth0 mac <mac address> arp 1 wlan0 mac <mac address> arp 1
Using WPA
The packages necessary to use WPA are installed by default, but the GUI does not have a way to enable or configure it. To do so, follow these instructions.
