Difference between revisions of "ATI Mobility Radeon X300"

From ThinkWiki
Jump to: navigation, search
(3D acceleration: - not sure about the removed claim)
(Clock rates, voltage and power)
Line 87: Line 87:
  
 
{| border="1" cellspacing="0" cellpadding="2"
 
{| border="1" cellspacing="0" cellpadding="2"
|+ ATI driver for Windows {{footnote|2}}
+
|+ ATI drivers for Windows {{footnote|2}} and [[fglrx]]
 
! Mode !! core freq !! memory freq
 
! Mode !! core freq !! memory freq
 
|-
 
|-
Line 100: Line 100:
 
Experimentally, the difference between the Performance and Battery settings under Linux with <tt>DynamicClocks</tt> enabled is roughly 0.3W and 3-4 degrees in GPU temperature on a ThinkPad {{T43}}. Further frequency reduction leads to display flickering or corruption.
 
Experimentally, the difference between the Performance and Battery settings under Linux with <tt>DynamicClocks</tt> enabled is roughly 0.3W and 3-4 degrees in GPU temperature on a ThinkPad {{T43}}. Further frequency reduction leads to display flickering or corruption.
  
Clock rates can be changed through [[Rovclock]], and are also affected by the [[How to make use of Graphics Chips Power Management features|<tt>DynamicClocks</tt> option to the <tt>radeon</tt> driver]].
+
See [[How to make use of Graphics Chips Power Management features]] for details on how to control this using [[Rovclock]], [[How to make use of Graphics Chips Power Management features|<tt>DynamicClocks</tt> option to the <tt>radeon</tt> driver]] and or the [[fglrx]] driver.
 +
 
 +
Presently the lowest idle-mode power consumption is achieved using the proprietary [[fglrx]] driver and
 +
# aticonfig  --set-powerstate=1 --effective=now
  
 
=== ThinkPads this chip may be found in ===
 
=== ThinkPads this chip may be found in ===

Revision as of 13:37, 20 November 2005

ATI Mobility Radeon X300

This is a ATI video adapter

Features

  • Chipset: ATI M22
  • PCI ID: 1002:5460
  • PCI Express x16
  • 32 or 64MB GDDR1 on-chip video memory
  • "HyperMemory": can use system memory for graphics processing
  • "PowerPlay 4.0" technology for dynamic engine cloc, memory clock and core voltage, refresh rate reduction and thermal status reporting.

See specifications from ATI, as well as the "snapshot" data sheet (referes to the 32MB on-chip, 128MB "HyperMemory" version).

Linux driver

Use Driver "radeon" in the xorg.conf file - it works at least for xorg 6.8.2, maybe older versions too. Currently (as of xorg 6.8.2) this will only give you 2D-acceleration, though. To enbable 3D acceleration as well you need to use the binary ATI driver fglrx.

There is also an open source Radeon driver with 3D acceleration support (merged into here recently), but it's still highly experimental and does not support all features.

ThinkPad LCD

Display on the internal LCD works as long as you set the monitor settings correct.

External VGA port

There are known problems. Both the radeon and fglrx drivers turn off the switching between internal and external port.

With the vesa driver

Using the "vesa" driver built into X.org, mode switching modes. However, this loses acceleration and some capabilities.

With the radeon drive

On-the-fly swiching doesn't work. To use both ports, start X without an external monitor, and then connect the external monitor. Both displays will be active, and cannot be switched off until you exit X. Note that if the external monitor is connected when X starts, the LCD will be deactivated and you will need to restart X. To have a reasonable refresh rate on the external monitor (the default is the LCD's 50Hz), use the following in /etc/X11/xorg.conf:

Section "Device"
	Identifier  "Videocard0"
	VendorName  "Videocard vendor"
	BoardName   "ATI Radeon Mobility X300"

	Driver      "radeon"
	Option      "DynamicClocks" "on"

	Option      "MergedFB" "on"
	Option      "CRT2Hsync" "50-75"
	Option      "CRT2VRefresh" "30-82"
EndSection

(Tested wth Fedora Core 4 on ThinkPad T43).

See also the related discussion about Additional options for the radeon driver.

With the fglrx driver

On-the-fly switching doesn't work either. To use both ports, either have the monitor connected during X startup, or force activation of both ports by adding

Option  "ForceMonitors" "lvds,crt1"

to the Device section in your /etc/X11/xorg.conf. Powering the CRT port consumes 400-500mW, regardless of whether a CRT is attached.

S-Video port (TV-out)

Works with the proprietary fglrx driver (as of version 8.19.10). To activate, add

Option  "ForceMonitors" "lvds,tv"

to the Device section in your /etc/X11/xorg.conf and restart X.

DVI port

??

3D acceleration

OpenGL 3D acceleration is proided by the proprietary fglrx driver (when DRI is enabled). Note that performance is affected by the power saving mode.

Linux kernel Framebuffer driver

radeonfb might cause problems with hardware acceleration under X on some systems, vesafb and vesafb-tng on the other hand has been reported to work just fine.

Clock rates, voltage and power

Clock rates, voltages and power 1
Mode core freq memory freq voltage idle 3DMarks (Windows, 1600x1200, LCD only)
Performance 300 230 MHz 1.15V 2.98 W 8.28 W
Balanced 183 210 MHz 1.00V 1.71 W 3.88 W
Battery 120 105 MHz 1.00V 1.61 W 2.74 W


ATI drivers for Windows 2 and fglrx
Mode core freq memory freq
Performance 297.00 229.50
Balanced 209.25 182.25
Battery 104.63 121.50


Experimentally, the difference between the Performance and Battery settings under Linux with DynamicClocks enabled is roughly 0.3W and 3-4 degrees in GPU temperature on a ThinkPad T43. Further frequency reduction leads to display flickering or corruption.

See How to make use of Graphics Chips Power Management features for details on how to control this using Rovclock, DynamicClocks option to the radeon driver and or the fglrx driver.

Presently the lowest idle-mode power consumption is achieved using the proprietary fglrx driver and

# aticonfig  --set-powerstate=1 --effective=now

ThinkPads this chip may be found in


FOOTNOTES [Δ]
  1. according to the "Snapshot" data sheet (which refers to the 32MB on-chip, 128MB "HyperMemory" version)
  2. inspected using Notebook Hardware Control