Difference between revisions of "ThinkPad 11a/b/g Wireless LAN Mini Express Adapter"
(→X61 WiFi LED blink on transfer) |
(→ThinkPads this card may be found in) |
||
| Line 66: | Line 66: | ||
=== ThinkPads this card may be found in === | === ThinkPads this card may be found in === | ||
* {{T60}}, {{T60p}}, {{T61}} | * {{T60}}, {{T60p}}, {{T61}} | ||
| + | * {{R60}} | ||
* {{X60}}, {{X60s}} | * {{X60}}, {{X60s}} | ||
* {{Z60t}}, {{z61m}} | * {{Z60t}}, {{z61m}} | ||
Revision as of 16:18, 29 September 2008
ThinkPad 11a/b/g Wireless LAN Mini Express AdapterThis is a WiFi Adapter that is installed in a Mini-PCI Express slot Features
|
.jpg)
IBM Partnumbers
IBM Option PN (US): 40Y7026
Linux WiFi driver
Use the Madwifi driver. This driver has support for Atheros rev 0x0024 support since svn revision 2360.
OR (not recommended)
get the driver from http://www-307.ibm.com/pc/support/site.wss/document.do?lndocid=MIGR-52527 and use ndiswrapper
Hardware switch
Some ThinkPads have a hardware switch that must be in the on position for the radio to work, regardless of driver state:
(Note: This may not always be the case. On at least one T60, model 2007-62U with Atheros AR5212, running Ubuntu Edgy with the MadWifi driver, the wireless switch has no effect. Wireless operates with the switch in either position. But there's an experimental patch which adds support of the switch to ibm-acpi.)
T60 WiFi LED
Problem: The WiFi LED on the T60 isn't enabled by default on bootup.
Solution: As root edit /etc/rc.local by adding the following command at the bottom:
echo -n 1 > /proc/sys/dev/wifi0/ledpin;
Save your changes, afterwards on every boot up the WiFi LED will be enabled.
Note:This has been verified on a T60 1953-D7U running Fedora 7 Linux, however this should work on most Laptop-OS configurations.
X61 WiFi LED blink on transfer
Howto make the wifi led blink when there is network traffic. I've only tested this on an X61 with AR5212 802.11abg - AR5BXB6 on Debian/Ubuntu
sysctl -w dev.wifi0.ledpin=1 sysctl -w dev.wifi0.softled=1 //change the 1 to anything 1-9 for a more responsive blink
If you would like for this to occur on boot, add
dev.wifi0.ledpin=1 dev.wifi0.softled=1
to
/etc/sysctl.conf
